Posted by Hugh MacKay on March 04, 2009 at 18:39:15 from (209.226.106.109):
In Reply to: Re: 666 opinions posted by Steven f/AZ on March 04, 2009 at 17:28:19:
Steven: My issue, my 656 at 15,000 hours, still had all it's original tyrods, spindles, main pivot pin, etc. 1066 a very little heavier front end had been completely rebuilt 3 times in 15,000 hours. 1066 never had a loader, yet it broke two spindles from front wheels bogging down insoft ground. Yes I believe operator could have been a bit more alert, however at 6 mph there was little time.
Lets face it these issues just don't happen with articulated tractors. Sure we can go conventional tractor with front drive and 24" front tires, however I see guys rebuilding those every 5,000 hours, not cheap either. The first and only time I replaced articulation joint on my Deere was at 11,000 hours, pivot only the steering cylinders were fine. As I recall those upper and lower replacements were under $100.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.