Posted by Hugh MacKay on March 04, 2009 at 08:44:52 from (209.226.106.127):
In Reply to: Re: 666 opinions posted by mkirsch on March 04, 2009 at 05:57:06:
Kirsch: Since the 300, 350 and 460 only had a 10" clutch, could you explain why a SH needs a 10.5" clutch. M, SM, SMTA, 400, 450, 560, 656, 666 and 686 all had an 11" clutch.
Truth is during the 1950 there was great advance in casting, gears and clutch technology, those items didn't need size increase to add six cylinder engines up front.
Look ahead to 1975, 140 had a 9" clutch, everything from 140 on up to 70 hp had an 11" clutch, 766 and 966 only had a 12" clutch, 1066, 1466 and 1566 were all 14" clutch.
I've had the transmission top off my 130, H, 300, 560 and 656. I can tell you all gears in H and 300 are a lot closer in size to 130 than 560 or 656 and 656 is heavier than 560.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.