Posted by Clefus on January 17, 2009 at 20:48:55 from (98.21.20.155):
I am in need of some good advice on plumbing a project..
I am building a tow behind lime spreader, '74 IH dually dump chassis, v-box with horizontal feed auger and spinner..hooked to tractor hydraulics ( open port..not valved from tractor)..
Ive attached a schematic of what I think I may need....not sure..
I have the auger/motor and will get the spinner setup ...both will be hydraulic motors...
Can I use the flow valves like I've drawn ??
Can I route two returns teed into one back to the tractor ??
Or what do I need to do to plumb this up??
Also not sure how wide one spinner will spread...may need two...
I just need sound answers...buying one is out of the question...I have most of the material here.....and I need to get the lime spread in spring....some ground is too rough/steep for a truck and want to do it at my convenience...not rely on others...no renting ect....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.