I picked up a football-sized frozen clod of dirt on the bottom of the low side the other day and that worked as a pretty good skid. That got me thinking of rigging some kind of skids for this year. Since I don't have any down pressure it already tends to ride over drifts instead of scooping them up, but skids might be the ticket for this year.
I was trying to use the same holes on the spreaders (? the flat bars that come back from the axles?) and was afraid to jack the left side any higher when I first did it.
Armand- I can certainly take some pictures. I'm a terrible welder but I got a friend to to it for me. If I recall correctly I took 3-4 L-shaped pieces, about a foot long and put one inside and one outside on one leg of the U, then one outside on the other (no room in the channel for another one, so we didn't weld on the fourth one. That covered the holes.
Gordo -- I'm up by Brookings, so Mitchell isn't too terribly far away. I'm not sure what my long-term plans are for this M anyway. I got a "new" Ford ('62 4-cylinder 4000) this year, and if I can rig a loader for that I might let the M go. At least, that's what I promised my wife when I was scraping to buy the Ford. I love the 3-point and power steering but the M has more character (and I can't get the ford started right now...) I may end up keeping both, as I tend to not let things go. A dedicated loader tractor and another for mowing and such would be pretty swell, providing I can find a place to keep them both. I guess let's hold off till spring, and if I'm looking then I'll drop you a line.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
