Posted by John T on November 18, 2008 at 07:49:38 from (66.244.97.31):
In Reply to: farmall h wiring posted by t martin on November 18, 2008 at 07:21:01:
AS far as the charging system, the 4 position LHBD was for use with a Cutout Relay while the 3 position OBD was for use with Voltage Regulators.
If a Cutout Relay is used you need to be able to regulate the gennys charge rate and thats done by wiring its FLD post up to the LHBD switch so it gets a dead ground (High charge) or a resisitve ground (Low charge)..
If a Voltgage Regulator is used the gennys FLD post wires to the FLD terminal on the VR so theres no need for any genny to light switch wiring, the VR controls the charge rate i.e. you dont need LOW and HIGH charge light switch, the light switch controls the LIGHTS ONLY NOT LIGHTS PLUS CHARGE
As far as any rear light use and what switch Jim or Bob M can answer better then me I havent owned IHC in yearsssssssssssssss
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.