I used to just put a big pipe wrench on them, but too often left a couple bite marks :oops: On the other hand, probably not too bad if it balances out the marks where someone had hammered it years earlier. :lol:
Haven't tried it on a gas cap, but I wonder how a chain wrench would fair?
Dry ice like Bob mentioned may work well, even better if you can keep something warm around the neck;I have done that a few times, but again I haven't tried it on a gas cap.
If they are crazy tight, yet it's clean enough fill it with water through the bottom; heat may work; especially in combination with the dry ice. Of course if it's full of water (were these fully solid? I'll need to look), and you don't want to damage the edges at all, you could braze a big 'ol nut on the top and wrench on that; melt it off later and clean up the brase with a wire wheel or a file and sandpaper. I done that to quite a few things, but yet again not a gas cap......
....I better bite my tonque now, as I haven't taken the caps off that 22-36 yet! :wink:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.