Posted by RN on October 02, 2008 at 12:56:14 from (96.60.81.245):
In Reply to: m pto speed posted by ckfarmall on October 01, 2008 at 20:42:04:
Trying to remeber old M speed- governor was 1600/1650 full trottle and PTO would do the 525/560 range for nominal 540. Variations exist- 1450 governor setting on earliest, Super M with 1750/1800 governor had matching PTO gears- if your M was every rebuilt the later governor weights and springs may have been installed. Industrial 2000 rpm governor parts also exist and are sometimes installed- Don't think they had PTO gear ratio the same as standard but many Industrials didn't have PTO- had extra hydraulic pump instead. If you have a tach on M, check the 1450 setting first under light load, otherwise get set throttle 2 notches back from full and see how it works. RN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.