Posted by casered on September 27, 2008 at 09:33:47 from (71.173.0.88):
I took the valve assemblies off my 560 to rebuild them as they were leaking and I overhauled them according to my I.T. manual. Problem now is that when i moved the control lever the first time something snapped inside the valve. I found the gears for the control inside had some teeth missing, that weren't missing when I put it back together. I am not sure where I went wrong on it, as I followed the rebuild procedure in the manual on reassembly and have it timed according to their instructions. I got rid of the leaks but have a bigger problem now instead.
My question is what could I have put together wrong? Does the hitch need to be up or down when reinstalling the followup control or does it not matter? I realize with the gears broke it will not work, but was not sure what to look at when I get them and start putting it back together. I was hoping to be able to use this tractor during harvest season.
I called my Case dealer this morning and they said the gears are N.L.A. with the exception of one. but I need them all. Anybody got a good used set?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
