Posted by P and R Pete on September 23, 2008 at 11:08:29 from (205.238.236.103):
In Reply to: Farmall A clutch problem posted by john in pennsylvania on September 23, 2008 at 07:23:06:
John, just in case you've never adjusted your clutch yet, here's a picture from my Super-A, where the adjustment is done. The inspection hole is at the rear of the torque tube, underneath. (I'm trusting that the A and SA are the same)
#1 is the yoke attached to the brake pedal, and it's 'horseshoe'-shaped, and loops up and over the nuts and threaded rod and down again, and is all one piece.
At #2, there is a hole in the yoke which is NOT threaded, (much as it may look like it is), and is there so that the threaded rod can move back and through the yoke.
#3 are the two nuts that do the adjusting. The pedal pushes the rod forward, which pushes the throwout bearing forward to engage on the clutch. So if your clutch is already too tight, you have to work those nuts to get the rod to move rearward a sufficient amount to get an inch of freeplay at the pedal, like Dave already said.
If I don't have this bass-ackward (LOL), loosening the right nut, and 'tightening' the left nut will pull the rod rearward. When you have it right, re-tightening the right nut will lock the adjustment.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.