Where would someone begin to look for the proper mounting brackets for these loaders? I have an IH 2000 on a 330U and suspect my front brackets are not the ones I should have. With a load in the bucket the flexible joint from the steering arm to the right wheel spindle is hanging up on the underneath of my loader frame. Pretty sure it's cleared the zerk fitting right off at some point.
mkirsch said: (quoted from post at 11:06:11 07/10/08)
Unless it came off the same tractor, or one with a similar frame like a 656, it won't be a bolt-on fit.
If you've got fabrication skills you can modify the mounting brackets.
From what I've been able to glean, and Jim Becker's article in the current Red Power magazine, the 3000 is a heavy-duty version of the 2000 loader that was installed primarily on Industrial or Utility tractors. More than likely yours came off something like a 2656 Industrial and will not bolt on to a Farmall 460 without heavy modifications.
This post was edited by Bringselpup at 15:42:25 07/10/08.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.