Posted by Charles Todd on February 22, 2008 at 11:20:15 from (205.242.95.137):
From my research, the D-188 was not used on very many pieces of equipment other than the 504 and 2504. I do not know the exact figures, but the compression ratio of about 16.5 seems right. If I rebuild the engine (sleeves, pistons, head job, bearings, ect) and have a fresh build, could I shave the head. If I bumped the CR up to lets say, 17.1 - 18.1, would it give much more power? Would it run? Would it fly apart? I read a post a few days back about naturaly aspirated diesel engines having a low EGT, so I take this as there is room for improvement of what I currently have.
I am not interested in professional tractor pulling, but I would not mind trying it out this fall at the Louisiana State Fair :) Whatcha think?
I know, I am asking to blow the engine up... Could I retro-fit on a turbo? M&W did not make one for the 4 cyls but I know they have them for the 6's. Could I use my skills to graft one onto the manifolds with a light boost, turn up the fuel a little and shave the head without catastrophic failures or explosion?
Thanks again, it has been raining like crazy here and I am couped up inside with my mind racing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.