Posted by P and R Pete on February 11, 2008 at 17:24:32 from (216.37.144.101):
In Reply to: Crack in my crankshaft posted by P and R Pete on February 11, 2008 at 14:33:16:
Thanks, guys.
I guess std would be best, if possible, and if used, I'll be leaving any decision about the health of any crank I buy to my machinist. That part would be out of my league.
Gene, I'm not sure if you're offering one.
I'll e-mail you guys one-by-one about prices. This project is getting costlier by the minute, and shame of it is, I have to pay attention to my budget.
This started because my clutch was slipping like crazy, and while I was in there, I wanted to do bearings and rings. Like Jack said, to do it right. I found a mis-matched piston, two rods swapped in their cylinders, a scored (and now cracked) crankshaft.
Glad I decided to look at it all.
BTW, my pressure plate was badly warped. Three areas had grease on them and weren't making contact at all.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.