Posted by chadd on September 25, 2007 at 14:17:47 from (155.92.33.252):
In Reply to: Tranny oil level plug posted by JohnG(TX) on September 25, 2007 at 13:44:37:
Part of the consideration is efficiency, part of it is cost. Gear lubrication is for the most part accomplished by the oil climbing up the gears as they rotate. In this manner, the oil gets thrown throughout the housing and into channels to carry it to other bearings, gears, and moving parts. If the transmission is filled to the brim, you have a significant friction loss on every submerged rotating surface, instead of just on the fraction of teeth submerged on the lowest ones. All of the spinning gears, bearings, and shafts churning and circulating the oil would add up to a lot of resistance, thereby greatly reducing the efficiency of the gearbox, especially when you start talking about 90W-140 gear lube. Also, it would be pretty darn expensive to fill the entire rear end case with fluid on one of these tractors, as there is a lot of space in there. Temperature is also a factor, as the fluid will expand.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.