Posted by ScottyHOMEy on September 20, 2007 at 18:23:06 from (71.241.196.242):
In Reply to: Farmall BN buddy seat posted by jward on September 20, 2007 at 08:46:20:
With acknowledgment to all the safety concerns . . . in my day we sat on top of the shaft housing with our feet resting on the drawbar anchor, and held onto the fender if needs be.
Otherwise . . . The BN is simpler than the B, in that you need two seat supports (maybe easier to come by for ther commonality with the A) that will bolt up to the tranny and the flange on the final drive. DaveH's suggestion to chase out the threads on the tranny end sounds like a good one to heed. An a or BN floor pan, with mods for the switch from left to right (again chasing out the mounting threads) a couple of springs and a seat, and I should think you'd be home.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.