Farmall & IHC Tractors Discussion Board |
Re: Working on the M....hydraulic pump.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wayne from MN on August 10, 2007 at 08:10:09 from (66.228.250.13):
In Reply to: Working on the M....hydraulic pump. posted by Patrick Martin on August 09, 2007 at 22:32:05:
I just installed the belly pump in an H last week by myself; I used a 2" ratchet strap over the center housing and under the pump to "ratchet" it up into place. It took about 3 stop & block times to shorten the strap in the ratchet, and a bar in the lower hole to help align things. Put some "duct tape" over the fill pipe to keep things clean. Take your time & clean the bottom of the pump housing first unless you don't mind a little oil on the strap!
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|