Farmall & IHC Tractors Discussion Board |
Re: Farmall 300 Hydraulics . . . Again . . .
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Matt Weltz on August 06, 2007 at 19:15:20 from (167.142.225.158):
In Reply to: Re: Farmall 300 Hydraulics . . . Again . . . posted by georgeky on August 06, 2007 at 19:04:22:
When I had the reulator apart to replace the screen/plug I went ahead and pulled everything else out that I could easily get out out. The large piston appeared to be in good shape but I did not take out the seat and check the ball/spring underneath. However I was able to push the ball down and it popped right back up as it should have. The smaller piston under the large spring and retainer also looked fine to me. I marked the regulator block cover before I took it off so I know the passages inside are back in the correct positions. I am just not sure what to check for. I would think that if something was stuck, it would have continued to bog the engine down immediately after I replaced the screen/plug. As it took about 20 minutes for it to start doing it again, I beleive that the screen has collapsed again but I have no idea why or what I should look for now. Thanks for your help though...
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|