Farmall & IHC Tractors Discussion Board |
Re: 1066 turbo won't go into reverse
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by rockwood84 on August 02, 2007 at 14:37:10 from (216.79.252.190):
In Reply to: Re: 1066 turbo won't go into reverse posted by Owen Aaland on August 02, 2007 at 11:56:32:
thanks mr. owen for replying, it binds up down the vertical shaft that the has the splines on top of it. i tried to move the shaft and it will move about 1/4 inch. so its at the bottom of it where it is binding.i have not took the side plate off yet. still have some more hay to rake. but will take side plate off as soon as i get it raked thanks again
Replies:
Home
| Forums
Today's Featured Article -
Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|