Farmall & IHC Tractors Discussion Board |
Re: Farmall 300 Hydraulics Again
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Matt Weltz on July 30, 2007 at 20:01:55 from (167.142.225.158):
In Reply to: Re: Farmall 300 Hydraulics Again posted by georgeky on July 30, 2007 at 19:56:52:
Yes, I check everything out to make sure nothing was plugged or stuck. Everything functioned as it should. I had it running for a good 15 minutes today cycling the hydraulic and just letting it set. Like I said, the pump was about as warm to the touch as the side of the block. When the hydraulics were not being cycled, the engine would bog down every so slightly. Hardley enough to even know and a million times better than it was. I am guessing that is just how it should be. Plus it might just need used a little now; it had been sitting for 15+ years before I started re-doing it. Thanks for the help!
Replies:
Home
| Forums
Today's Featured Article -
Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|