Farmall & IHC Tractors Discussion Board |
OT wardner Icecream makers
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on July 19, 2007 at 08:43:09 from (199.17.6.122):
Two ideas: using a right angle drive from a bushhog etc, with a reduction to about 60 RPM drive a sprocket for gilmer style cog belt (I think cam sprockets from a single type of OHC engine would be perfect). From that going in a straight line place sprockets that are far enough apart to allow a tub to be located between each with a bit of wiggle room. Idea 2: Under the sprocket, on the shaft going down, make a shear pin based two disk clutch that has holes for a small Pencil sized stick. driving through this will prevent breakage of components when the pudding is ripe for its 1/2 hour of cold tempering after removing the dasher. Holes at differing distance from the center, and different "sticks" would be used to adjust the force. Put a pivoted support under each tub so the tub can be lowered from the drive (while the other tubs continue operating). (I teach product design at St Cloud State University, and enjoy this to the max) JimN
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|