Farmall & IHC Tractors Discussion Board |
Re: bull pinion slop
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Harold Hubbard on July 17, 2007 at 04:04:33 from (66.6.176.23):
In Reply to: Re: bull pinion slop posted by Bob Kerr on July 16, 2007 at 20:18:50:
WARNING!!! DO NOT pull the bull pinion cage without removing the bull gear. The cage is slotted on the back side, and the bull gear goes into the slot to mesh with the bull pinion. If you just pull the cage, it will catch on the bull gear, and if you keep pulling on it after it catches it will break. Don't ask me how I know! Actually it was a C that I learned on, the hard way, but they are all similar. On an M you can remove the PTO and sneak in that way to unbolt the bull gear, then remove the axle, housing and all, but it still makes a tough job of replacing those bearings.
Replies:
Home
| Forums
Today's Featured Article -
Fordson Model N: Field Service Operations and Lubrication - by Anthony West. The daily or weekly servicing of any vehicle is of the utmost importance, and in days gone by when our favorite tractors were doing an important and Commercially vital job on the farm, these service operations would make a major difference to the running costs and economy of the farm. This being so, it surprises me to see how many enthusiasts attending rallies, shows etc, seem to be unaware of the importance of this constant attention. Possibly the modern machine with its 6,000 mile or even once
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|