Farmall & IHC Tractors Discussion Board |
Re: Bad noise in b.n.engine help??????????
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Owen Aaland on July 10, 2007 at 22:22:33 from (65.165.246.40):
In Reply to: Bad noise in b.n.engine help?????????? posted by COPPER KAT on July 10, 2007 at 21:43:55:
Something has too little clearance. As it warms up and expands to siezes up. Places to look are crankshaft clearances on all bearings. Piston to sleeve clearance. Piston ring end gap. Oil pump gear end clearance. Since you said you found some silver flakes my guess would be the oil pump gear clearance. If the bottom plate was resurfaced (or even if it wasn't) it is quite possible that you will need more than one gasket there to get the proper clearance. Since it is aluminum it can quickly heat up and expand and also cool down quite fast to allow the pump to turn again.
Replies:
Home
| Forums
Today's Featured Article -
Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|