Farmall & IHC Tractors Discussion Board |
Re: magneto problem
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wild Bill on July 01, 2007 at 12:47:10 from (63.147.9.42):
In Reply to: magneto problem posted by O.B. on July 01, 2007 at 12:23:13:
Did you take the little rotor gears out? If so look for timing marks on them and mesh the marks together. If they don't have marks, estimate where the rotor needs to point according to #1 nipple with #1 at top of compression stroke. I know lots of folks say that low magnetism causes problems, but I have never seen a H4 mag with poor magnatism. To take the coil out, take the coil cover off and take the two screws out on either end of the coil. Then take the condenser out to get the coil lead loose; then lift the coil out. If you want to check magnatism, now you can. Stick a screw driver in the housing near the magnets, and if it'll grab that screw driver with a little authority you should be fine. If you have spark out the coil wires, the rotor being out of time is the number 1 reason for no spark out the sparkplug wires.
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|