Farmall & IHC Tractors Discussion Board |
Re: H Generator Update
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on June 29, 2007 at 06:23:32 from (66.244.83.147):
In Reply to: H Generator Update posted by JW in NH on June 29, 2007 at 04:39:31:
CONGRATULATIONS JW, Once a VR"s contacts get burned or carboned up n stick occasionally to where a good SMACK can release them, unfortunately grrrrrrrrrrr it may not be too long before it needs replaced cuz they could stick more permanently. It can help to non abrasively clean/buff/polish them but use caution in filing etc too much cuz once that shiny silver coating is gone they dont last long. If cleaned (or maybe they just needed exercised from sitting) they may never stick again, hopefully. On the genny brushes, stuck or gummed up or corroded brush hold down spring assemblys is a major cause of non charging. They need to be cleaned and then light lube the spring hold down assembly and exercised (flipped held open n then released closed) now n then plus keep the film n oil n carbon off the commutator is alllllll good preventitive maintenance. best wishes
John T
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|