Farmall & IHC Tractors Discussion Board |
Re: H rear end update HELP!!!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by williamf on June 26, 2007 at 14:21:54 from (66.82.9.53):
In Reply to: H rear end update HELP!!! posted by Bob Kerr on June 26, 2007 at 12:41:07:
When I did much the same to mine I didn't have to replace the input shaft and its gear or the constant mesh gear on the lower shaft, just the fourth/fifth slider. But I did replace the bearings at the front of both shafts. That change in alignment is enough to make the constant mesh gear whine pretty loudly in every gear except fifth. Fifth is silent. I've decided to live with it. All the rest of the gears look like they should have been changed, and when I have to, I will. On the other hand, you said that when you mash the clutch the noise stops. Does it whine sitting still, not just when moving? That may mean that it's bad enough to warrant another look. Somebody who knows more than I should be along to say. Good luck, Wm
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|