Farmall & IHC Tractors Discussion Board |
Re: Farmall C overhaul
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on January 23, 2007 at 18:32:12 from (66.173.50.65):
In Reply to: Farmall C overhaul posted by thumbanger on January 23, 2007 at 15:00:50:
Here is my take on it. There are few parts available (one can find some gears, but no housings. Disassemble and clean with carb cleaner to bare metal (include the strainer in that) the cap (covering the gears) is usually worn some where the gears press against it, laeving a mark. This needs to be flat sanded out with 240 silicon carbide paper on a piece of glass (flat). move the cover in random directions and press down evenly while sanding. change to 400 grit to finish it nicely. Use a feeler gauge set to assess the clearance between the gears and the side of the housing. if it is more than .0015" between them, I would try to get a better housing. The cover to gear distance should be set with very thin gaskets (some are available) these should allow only .001 to .0008" clearance between gear and cover. Can be checked with plastigauge. When finished, put liberal amounts of engine assembly grease/lube in the gears and housing (including the shaft/housing area. This assists in the priming of the pump on first startup. I hope this helps, JimN
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|