Farmall & IHC Tractors Discussion Board |
51 Cub Piston rings - how to install
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Kurt in Va Beach on January 22, 2007 at 18:51:36 from (4.136.27.183):
Hi All, I just got my cub engine back from the engine shop and want to start to put back together. I have new oversize cast iron flat top pistons and need to install the ring set - 'Red Power' by Perfect Circle. The directions are pretty good except for the oil ring, talks about the thin steel rings that go on either side of the oil ring, but then there is another thin "clip spring" with 7 sides that completes a "circle". This looks like it would go in the grove flat side wraps around the piston. Where it's job is to keep the oil ring an equal distance from pushing in against the piston. So that's my question, is this the way it should be installed? Or Not? The engine shop tossed my old pistons so I do have them to compare. thanks for the help, you guys on the forum are great!! Kurt
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|