Farmall & IHC Tractors Discussion Board |
Re: Holes Behind Gear Shifter
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gene-AL on January 17, 2007 at 17:35:07 from (74.226.30.242):
In Reply to: Re: Holes Behind Gear Shifter posted by SuperA-Tx on January 17, 2007 at 13:59:47:
I'm not Sam, but I have one of these - The McCormick A-151 Disk (turning) Plow for a Super-A does have a long rod attached to a plow steering arm mounted on the right front steering knuckle of the tractor. This steers the wheel on the rear of the plow to follow the tractor's steering. The plow has dual-disks which can be adjusted for a 14-20" wide cut, depending on soil conditions. The plow is mounted much like the drawbar, and working depth is controlled by the hydraulic touch control. There is also a hand lever to raise and lower the plow wheel to set the working depth range. No problems with hanging up on roots and rocks with this plow, it just climbs over those it can't cut or move.
Replies:
Home
| Forums
Today's Featured Article -
Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|