Farmall & IHC Tractors Discussion Board |
Re: International 424 loses oil pressure on gauge
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by El Toro on December 13, 2006 at 16:16:04 from (205.188.116.133):
In Reply to: International 424 loses oil pressure on gauge afte posted by Delbert Homebo on December 13, 2006 at 15:34:59:
I would check to make sure the oil gallery on the engine isn't clogged with sludge. Remove the gauge and connect a short piece of hose to where the gauge was installed. Then have someone crank over the engine and see if any oil is being dicharged from the hose. If you good oil flow I would find a calibrated gauge and install it to determine what the oil pressure is. If it still reads zero, I would drop the pan and check the oil pump. The relief valve on the pump me be stuck open. I wouldn't run the engine until you determine the problem. You could do major damage to your engine. It must have some pressure or you would have bearings knocking. Hal
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Silver King - by Staff. Silver King tractors were produced by the Fate-Root-Heath Company of Plymouth, Ohio. The company was founded by John Fate in 1884 and was originally called the "J.D. Fate Company". After several mergers over the years, the final company name of Fate-Root-Heath came about in 1919. The first tractor produced was actually called the "Plymouth" tractor and was powered by a 20 HP 4-cylinder engine with a 3x4" bore and stroke. The four speed transmission had a top speed of 25 mph! After more t
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|