Farmall & IHC Tractors Discussion Board |
UPDATE: Re: Super A - new pistons. won't turn
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RCA 49SA on November 25, 2006 at 17:29:41 from (72.82.58.108):
In Reply to: Re: Super A - new pistons. won't turn posted by teddy52food on November 25, 2006 at 15:16:31:
I did the pistons one at a time so did not get them or the bearing caps mixed up. I just got in from pulling the pan and loosening each cap, checking the bearings, regreasing and putting each on only finger tight. Still hard to turn by hand. Has to be the rings or pistons I guess. New rings looked just like the old one except the old oil ring had no expander and the new one did. I put in the expander. The pistons were really tight going in and I thought this was a good thing! I will check the block tomorrow for other issues but expect to be pulling the head again. 1. Used copper spray on the head gasket. Can this be used again after I pull it without problems? 2. If I drive out the pistons, will the rings stay okay or am I looking at another set? This should not be this tough. Wish I had gone ahead with new sleeves and pistons with matching rings at this point and may yet end up there! Any other ideas?????
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|