Farmall & IHC Tractors Discussion Board |
Cub hydraulic repair
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by banjo on November 17, 2006 at 12:32:33 from (65.67.203.158):
I've been over on the cub forum and received some help. But I'll run it past ya'll. I took the block off and have it tore down and new 0-rings installed where i removed old ones.But i have 1 left over and connot find any place it could go. Plus i do not seem to have a releif valve or screen(cannot find where one was supposed to be).And the orifice screen seems to be MIA. Thee are the 0-rings i have replaced. 2-acuator seal ring, 2-piston seal rings, 1- piston head seal ring, 1- regulator valve seat, 1- regulator valve piston seal ring,1- control valve seal ring. My connecting rod yoke has a tapperd shaft so it did not have an 0-ring there but i still have 1 left for something else that i cant figure out. Did some of the cubs not have the releif valve plug and screen? there are no threaded holes under the bottom cover just the 3 allen head plugs.Thanks
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|