Farmall & IHC Tractors Discussion Board |
Re: australian made farmall
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on October 21, 2006 at 06:47:47 from (209.226.247.132):
In Reply to: australian made farmall posted by inoz on October 21, 2006 at 04:49:34:
inoz: If you go into the archives here at YT there is discussion about British and Austrailian built Farmalls. They are quite different from American built Farmalls in three real noticable ways. First they have always used a glow plug, direct start diesel, secondly thay always had a factory 3 point hitch going all the way back to the early 50s. Finally sheet metal used on British and Austrailian Farmalls were never the same as American Farmalls at any given time except in the days of the M. They never used American 00 or 50 sheet metal. what we know as letter series sheet metal styling was used into the mid 1960s. At that point the whole configuration of the British tractor changed. The Austrailian tractor around 1965, two years after the end of American 460-560 production. started using 60 series sheet metal out front but retained the M type dash and fuel tank.
Replies:
Home
| Forums
Today's Featured Article -
Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|