Farmall & IHC Tractors Discussion Board |
Re: Ploughing with a Super A?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by VAJerry on October 16, 2006 at 18:31:31 from (69.19.14.23):
In Reply to: Ploughing with a Super A? posted by tractorsam on October 16, 2006 at 16:56:14:
I had the same thing when I first hooked mine up. 1. Reverse the drawbar and put it on the front of the drop cases. 2. Remove the two bolts and allow the drawbar to pivot up and down. 3. Mount the plows. 4. I used a chain (There is a flat rod to connect the two but I did not get it when I bought my tractor) to run from the drawbar to the touch control arm that moves when you raise and lower the rear rock shaft. on the right side of the tractor. 5. play with the length of the chain until you get the penetration you want. The points of the plows need to angle down for penetration.
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|