Farmall & IHC Tractors Discussion Board |
Re: 1086 front end onto an 806D???
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on September 18, 2006 at 05:55:44 from (75.24.23.154):
In Reply to: 1086 front end onto an 806D??? posted by Brad in WI on September 18, 2006 at 00:37:10:
News flash here most of the parts that are used on a 560 are used on the 806 other then the 6 bolt hub . Tube and bolster spindels . I put a 560 ft. under a buddys 706 that he was using as a LOTDOG and the only time that we had a problem was that Brillion 15 foot culimulcher off the top of a semiload of eguipment and the mud of the spring thaw as it found a buried rock and snaped the left spindel . The loader would lift a Farmall M with a 319 new idea mounted picker mounted on her . I had to see if my fabracation on the loader and boom pole would hold up. Never boke the loader or boom pole just spindels when tryen to handel culimulchers or any wing disk over 24 foot
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|