Farmall & IHC Tractors Discussion Board |
Re: Farmall 140, rear axle housing oil
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Haas on August 25, 2006 at 19:11:08 from (12.65.0.250):
In Reply to: Farmall 140, rear axle housing oil posted by al altfater on August 24, 2006 at 19:07:20:
I guess you are aware that there are three places to put transmission oil in a 140. The transmission/differential housing, and each of the final drives. There is no drain on the final drives, the pans have to be removed. The final drives hold 3 pints each. The transmission holds 5 quarts if equipped with the PTO and belt pulley. Final drives fill to the bottom of the fill holes which are on the inside cast part of the final drive where the drawbar attaches. Transmission fills to the level plug located on the left had side front of the transmission case behind the brake rod. You have to disconnect the brake rod pin to get to the level plug. Don't overfill the transmission, as you will have trouble with leaks at the shaft seals.
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|