Farmall & IHC Tractors Discussion Board |
Re: 706 282 rebuild revisit
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on August 23, 2006 at 12:02:03 from (75.24.29.127):
In Reply to: 706 282 rebuild revisit posted by Aces on August 23, 2006 at 10:29:54:
Just went out to the truck and refreshed my sometime for get full old mind and reread the section on the 282 earlie and late production sleeve fit and according to THE BOOK they all were PRESS FIT the earlie ones were of what they called a LIGHT press fir that required 75-250 lbs of force on the gauge of the dual piston sleeve puller installer and the later ones required 750 lbs to 2500 lbs of pressure on the GAUGE . THe reason for this change was that OH wiat the light press fits were getting sucked down around the crank. and also the blocks may be stamped S1 ,S2, and S3 as it seams that they has oversized sleeves that ranged from .002 to .010 over bore . to tighten up them engines . as i has been some 12 years according to my old paper work that i rebuilt one of them and my mind is not a 2.5 giggabite computer and i have to at time go to the books for the facts.
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|