Farmall & IHC Tractors Discussion Board |
Re: ChadS Help!!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ChadS on June 26, 2006 at 13:58:17 from (66.228.96.131):
In Reply to: ChadS Help!! posted by MJF on June 26, 2006 at 13:14:16:
You just have to set the head on the block without the head gasket, rotate the engine by hand till TDC, and see if it hits. if it does, then that slant will have to be ground into the head on the intake side of the combustion chamber. Some piston styles hit, some dont,, if the fire craters are from a late SM to 450,, then they will hit the 8060 and the 8574 heads,, if they are from a M,, you should be good to go and have no troubles. Look for firecraters that have the big diameter wrist pins,, those were used with both gas head versions and had no problems, the newer style engines, 400-450"s, the domes were wider across and needed the slanted side in the chamber to clear. on the 8060-8574 heads, the area in question is pretty thick,,, should be plenty of room to grind. Chad
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|