Farmall & IHC Tractors Discussion Board |
BN not charging
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BobOHIO on June 25, 2006 at 06:37:46 from (66.153.35.200):
I have been reading archives for days and trying to figure out the charging system problem. My BN has a magneto and lights with a 6 volt pos ground. Am using the 4 post VR. When it runs shows slight discharge. Turn on lights and discharges to almost 15. Lights don't change with throttle change for dim or brightness. Voltage across battery shows 6 with tractor running 3/4 throttle. This is what I did: 1. Belt is nice and snug 2. Grounds cleaned with sandpaper. Jumper wire to ground made no difference. Ohm meter between VR and Gen and frame reads 0. 3. Wiring is all new and according to John's instructions. I am confident that it is correct. 4. Gen 3rd brush is already set 3 bars from the other one. 5. Ground F terminal on gen while running and no charge. 6. With F term grounded ran jumper from A to Bat and it DID CHARGE to almost 15 on the meter. 7. Remove VR cap and tried to adjust spring to hold set of points closed (made spring tighter) with no change. 8. Layed screwdriver across the coil and points and it DID Charge again. 9. Bought a new VR from tractor supply. Connect battery and polarized it and still no charge I even read about the guys who said there system didn't charge until running it for awhile then worked. Let it run for awhile with no change. One note: the VR I bought had been opened and I think returned. Could it be bad? Or am I missing something? I am super frustrated. Please help. Thanks
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|