Farmall & IHC Tractors Discussion Board |
Re: farmall 806 hydraulic
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on June 23, 2006 at 08:21:14 from (64.179.117.85):
In Reply to: farmall 806 hydraulic posted by roytex on June 23, 2006 at 07:27:07:
Well it is not that big of a deal if it is the shaft seal . First you will need two long 1/4 inch fine thread bolts . I use a 6 1/2 inch long ones a steering wheel puller a 1/4 fine thread tap and a impack to remove the retaining nut a pair of snap ring pilers and a seal kit that will run ya somewhere around 15 bucks . Remove the steering wheel and remove the snap ring , then replace the steering wheel and give it a quick turn either way and the seal should pop wright out . THen install the new seal and bushing and replace the steering wheel . Now if the outer seal is leaking then get back with me and i'll walk ya thru that one.
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|