Farmall & IHC Tractors Discussion Board |
140 Lift system
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Avery on May 12, 2006 at 04:18:30 from (206.107.117.6):
Pump on 140 I had had gotten weak. Worked ok on everything except disk which is heavier. Was getting some hydraulic fluid in crankcase. Was almost sure it was pump so replaced. Made slightly better did not fix. So I went ahead and put kit in it replaced gaskets o rings etc. several which did indeed need replacing. This helped even more. Tractor picks up disk which is probably about 500 pds better. However, it still not exactly like it should. Takes about 5-6 seconds for lift to complete cycle. Plenty of pressure is there. If tractor is moving like you turn around at end of row comes up much quicker. After looking closely at pump which did not do when I replaced original which was on tractor for 46 years. I am beginning to think it may be rebuilt pump of An Farmall A. or maybe even a cub. After closer inspection it does look maybe little smaller than pump I took off and smaller than one on 74 140 also have. I lean toward A. Am now thinking about relacing o rings in original pump and putting it back on and see what it does. Anyone got any thoughts on this from what I described. Always look at Hugh McKay's posts cause he seems to be on mark anywhere 140 or Super A concerned. When I replaced pump it bolted right up no problems. So Im wondering if an Farmall A pump was same as supers and 140's. It look like to me if it was a cub pump would have had problems bolting up. In meantime am going to run some cause need to get some soybeans planted. Don't reckon it would hurt anything ? Appreciate ideas. Thanks...
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|