Farmall & IHC Tractors Discussion Board |
Re: Need hydraulic help, NH3 valve on air seeder
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by billonthefarm on April 10, 2006 at 19:02:13 from (204.42.18.221):
In Reply to: Need hydraulic help, NH3 valve on air seeder posted by Steven@ND on April 10, 2006 at 18:11:04:
Steven I have seen it done like that and it did work. I know they were hooked into the main raise lower lines. In any system the cylinder that needs the least pressure will move first. My recolection was that before you raised the nh3 toolbar if you bumped the lever it would shut off the flow and then wait a second and then complete the lifting. When you lowered the weight of the implement will keep the valve for the nh3 closed untill the implement was in the ground. Good luck and make sure you try it a few times before you go to the field. bill
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|