Farmall & IHC Tractors Discussion Board |
Re: Changing Ring Gear on Super C
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on March 27, 2006 at 07:40:34 from (64.179.117.92):
In Reply to: Changing Ring Gear on Super C posted by CharleyFarmall on March 27, 2006 at 03:09:54:
Well, like the othres have said the oven works , but if like to keep special body parts intacked from the wife and her butcher knife if yo have a torch and a pice of plate steel lay the flywheel next to it and lay the ringgear on the plate and use the torch and warm the ringgear with the torch you do not have to get it cheery red just warm 350-400 degrees and with a pair of good welding gloves just pick it up and drop it in place and make sure that it drops flat and stays flat till it cools . THe steel plate helps it heat evenly and hold the heat while you shut the torch off and lay it down done this in the field several times and works well. And you do not have a mad wife .
Replies:
Home
| Forums
Today's Featured Article -
Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|