Farmall & IHC Tractors Discussion Board |
Re: 1066 Left Brake-Head scratcher- T. Vet
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Blazing Bruck on March 03, 2006 at 17:11:12 from (206.40.122.130):
In Reply to: 1066 Left Brake-Head scratcher- T. Vet posted by Michael Sheik on March 03, 2006 at 05:28:10:
First of all, make sure the bull gear shaft hasn't migrated outward during disassembly. Once in a while they will "fall" outward slightly, and the taper on the tapered roller bearing on the inside of the bull shaft will prevent you from getting the outside piston housing to push all the way in. Cure; Jack up the rear wheel on that side. Put the piston housing in as far as it will go, put in 2 short capscrews to pull it in, and turn the rear tire at the same time. Without the piston housing in correctly, it's next to impossible to do the brakes.
Replies:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|