Farmall & IHC Tractors Discussion Board |
Re: Farmall A water elbow
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by El Toro on February 28, 2006 at 10:04:58 from (205.188.116.133):
In Reply to: Farmall A water elbow posted by maude on February 27, 2006 at 19:56:12:
You can drill and tap yours as Gene suggested. You would need to use an R tap drill if the temperature gauge is 1/8 pipe thread and then use a 1/8 pipe tap to cut threads into your pipe. If it's 1/4" pipe thread on the gauge you need to use a 7/16" drill as the tap drill. Then use 1/4" pipe tap to cut threads into your pipe. You can have a reducing bushing that will fit the temp gauge threads silver soldered on the elbow. We did this a lot to install thermocouples. Hal PS: The bushing would need to drilled and install a short pipe nipple so you don't mess up the threads when you drill.
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|