Farmall & IHC Tractors Discussion Board |
Re: Mag Switch
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MagMan on February 02, 2006 at 18:04:18 from (205.188.116.133):
In Reply to: Mag Switch posted by Elk Farmer on February 02, 2006 at 15:45:54:
Hey there elk farmer thats no problem. Just take the two screws out of the part on the side of the mag unhook the cable. Then pull it off there should bea nut underneath with a hole tapped in it for a small screw bolt. If not I can send you one then hook a wire up to it run it back to the seat and you find an on and off pull switch and hook it up or any kind of switch that would ground to the tractor when you switch it. Or you can do what I do and just take the wire wrap it around the light and ground it when you want it to quit. I would really like one of those switches for my 40 H if you want to part with it. JON
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|