Farmall & IHC Tractors Discussion Board |
removal of W6 clutch and tranny
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by mwilke on February 01, 2006 at 12:06:16 from (64.24.211.224):
I need to pull the tranny of my W6 because I have a gear with missing teeth. I am trying to follow the directions in the service manual which says to "remove the clutch unit." I am not getting very far and don't want to break anything else. I must be missing a step. I have taken all the bolts loose around theclutch coupling,the release sleeve carier and the clutch release fork. At least I think I have correct items loose. The next directiion is to "remove the clutch release shaft." I assume that is the splined shaft that runs into the clutch plate within the pressure plate assembly. I can't seem to pull it out far enough. It will slide out to within about 1/2 to 3/4 of an inch of clearance. It binds up against the opposite shaft in the front bearing cage of the tranny. Can the clutch plate be pushed further in somehow? Or, what am I doing wrong? Thanks in advance. Mike
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|