Farmall & IHC Tractors Discussion Board |
Re: m timing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MagMan on January 07, 2006 at 18:45:43 from (64.12.116.136):
In Reply to: m timing posted by in oz on January 07, 2006 at 18:36:19:
This is what I do make sure #1 TDC compression put your timing marks on the first notch on the pulley go a little bit farther then trip the mag just past # 1 on the rotor make sure its # 1 compared to the dist cap. install mag.When you install the mag turn it as far toward the motor as you can. Then turn the motor over backwards about 1/2 motor revolution . Then turn it back with crank or something simelar untill you get the first timing mark on the pulley lined up . Then slightly turn the mag away from the motor untill it trips and tighten it up. JON
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|