Farmall & IHC Tractors Discussion Board |
Anybody familiar with the Magnum motor?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by P Backus on December 01, 2005 at 21:08:40 from (69.128.32.197):
7140 Magnum with the Cummins 6TA 830. Some of you may remember last spring I was asking about coolant getting into the engine oil. Did all the tests, had the pan off, pressured it up, no leak. So I ran it this summer with just water in the cooling system,so as not to destroy the bearings, hoping the problem would become obvious. Nope, just kept putting the water in the oil. Anyway, my question is, is there anywhere in the timing gear area where the coolant can mix with the oil, like a frost plug or something. If you take the timing gear housing off, is there an opening to the water jacket covered by a gasket perhaps? The last couple of days of my fall work, it suddenly stopped losing coolant, but started leaking LOTS of motor oil out around the timing gear housing area. So what the heck- this doesn"t make sense. Just wondered if any of you remember what"s between the block and that housing. Thanks, Paul
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|