Farmall & IHC Tractors Discussion Board |
How much torque will it take
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John London, Tx on November 23, 2005 at 10:47:04 from (65.127.72.198):
Trying to get sleeves out of 43H that I had so much trouble getting the head off of a couple of weeks ago. Question today is how much torque can I put on the puller nut without damaging/ruining the top of the block. I've tried it heated as well as when cool and haven't budged the sleeve. Started with a 12" Crescent then used a 3/4" breaker bar and probably have 75 to 100# of torque on the puller now. Plan on letting it sit overnight and see if colder weather will help unless advised I can safely keep tightening the puller. Thanks!! BTW-Think the reason the head was such a problem is the stud between #2 & #3 cylinder had large rust pit just below the thread leaving the stud about 75% of original diameter.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|