Farmall & IHC Tractors Discussion Board |
Re: 966 Loader
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John A. on October 17, 2005 at 18:30:47 from (65.161.170.83):
In Reply to: 966 Loader posted by Jake047 on October 17, 2005 at 13:10:51:
Jake, Get an IH 2350 Mount-o-matic loader. As Nat said the mounts all bolt up to the existing holes in the frame. You can use your regular remotes for the Hydrolic controls, so no special joy-stick is needed. To get out from under it pull 2 pins and start backing out from under it. While letting it down.It is very straight forward. It will be some of the best money you ever spent. There are very few times I don't do something with mine It is on an ol 73 966. I have had it over 13 yrs and still can count the times it has been off on one hand. It seems every time I take it off I nned it back on sooooo why take it off. Later, John A.
Follow Ups:
Home
| Forums
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|