Farmall & IHC Tractors Discussion Board |
Re: 706, 263 engine rebuild Question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by K.B.-826 on October 05, 2005 at 16:40:04 from (68.115.103.185):
In Reply to: 706, 263 engine rebuild Question posted by Kelly C on October 05, 2005 at 08:18:59:
Kelly, I'm with Chad on this one. The time/work it takes to pull the fuel tank is better spent splitting the tractor and pulling the engine. It's so much easier to work on like that, plus you can check out the clutch and replace the rear main seal and transmission shaft seals, plus you can clean everything up much easier and not worry about having contamination left inside the engine. Keep an eye on Ebay for Blue Ribbon manuals, I&T manuals are decent, too. Make sure to replace the pistons, wrist pins, and bushings, those are the most common things to be worn out on that engine. Chad mentions oil leakage past the valve guides, but they're supposed to do that, to a point. Thats why you have to use Low-Ash oil.
Follow Ups:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|